01-16-2012 02:47 AM - edited 03-16-2019 09:01 AM
Hi Expert,
I need to order ATA 186 but this model already end so i have to order ATA 187 instead. Anyway, i use CCM version 4.1(3) so can i register ATA to CCM? Pls let me know if upgrade CCM to new version (I think version 8) is only way for solution. Thank you
01-16-2012 03:23 AM
You must upgrade to CUCM 7.1(5) or later for the ATA187 to work. The short answer is that it uses SIP which CCM 4.1 had no support of on the line-side of the system.
01-16-2012 03:27 AM
Hi,
According to the SW download page
You can run an187 on CUCM 6.1.5 +
You need to load
cmterm-ata187-qed.9-2-3-1.cop.sgn first to allow the device type part
of the CUCM device lists on the PUB only
See readme
http://www.cisco.com/web/software/282074215/64021/cmterm-ata187-9-2-3-1-readme.html
Then you load cmterm-ata187.9-2-3-1.cop.sgn
For upgrading and usage on all servers
So 4.1 to 6.1.5 should allow you to proceed
Regards
Alex
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: