Is there a reverse for....

Tony Davis · ‎01-20-2012

config ap primary-base controller_name Cisco_AP [controller_ip_address]

Once you config a primary controller to an AP, it would be nice to undo that configuration so that an AP is no longer locked down to a specified list of controllers.

Thank,

Tony

Darren Lynn · ‎01-20-2012

Off the top of me head I can't remember the CLI command but on the GUI you can just remove the config from the AP config.

WIRELESS AP section. Select the AP and in one of the TABS is the config for primary, secondary AP's

HTH

Sent from Cisco Technical Support iPhone App

Tony Davis · ‎01-20-2012

I am aware of the GUI options, but it's such a pain to do it this way. If the GUI is able to remove the config, there must be a CLI to do the same...

>>> darlynn 1/20/2012 5:45 PM >>>

Home ( https://supportforums.cisco.com/index.jspa )

Re: Is there a reverse for.... created by Darren Lynn ( https://supportforums.cisco.com/people/darlynn ) in Other Wireless - Mobility Subjects - View the full discussion ( https://supportforums.cisco.com/message/3540406#3540406 )

Off the top of me head I can't remember the CLI command but on the GUI you can just remove the config from the AP config.

WIRELESS AP section. Select the AP and in one of the TABS is the config for primary, secondary AP's

HTH

Sent from Cisco Technical Support iPhone App

Reply to this message by going to Home ( https://supportforums.cisco.com/message/3540406#3540406 )

Start a new discussion in Other Wireless - Mobility Subjects at Home ( https://supportforums.cisco.com/choose-container!input.jspa?contentType=1&containerType=14&container=2043 )

===========================================================

This message is confidential, intended only

for the named recipient(s) and may contain

information that is privileged or exempt from

disclosure under applicable law. If you are

not the intended recipient(s), you are notified

that the dissemination, distribution or copying

of this message is strictly prohibited. If you

received this message in error, or are not the

named recipient(s), please notify the sender

and delete this e-mail from your computer.

ETMC has implemented secure messaging for

certain types of messages. For more information

about our secure messaging system, go to:

http://www.etmc.org/mail/

Thank you.

===========================================================