01-21-2012 02:54 PM - edited 03-21-2019 05:13 AM
Hello,
The problem is when we try to register Cisco SPA525G2 softswitch TSIP, we get the message: "407 Proxy Authentication Required"
Sombody could advise how to configure 525G2 to send proxy auth.?
Thank you very much.
Andrey
01-21-2012 04:52 PM
Hi,
Please check the credentials you have entered.
You can see the proxy settings uder the extension tab on web interface of the phone.
Best regards,
Alex
*Please rate helpful posts
01-21-2012 05:37 PM
01-22-2012 02:50 AM
Hi,
You are already sending the proxy authentication. Check the settings on the server and if the proxy is correct, also the username and the password.
Best regards,
Alex
01-22-2012 03:18 AM
Hi,
I saw the traffic by wireshark. No proxy-authorization/authentification sentence in SIP header. See screenshort one from 525G2 other from Softphone. With softphone registration is ok.
01-22-2012 03:19 AM
the difference is obvious. 525G2 does not sent proxy-auth. clause.
01-23-2012 02:19 PM
Hi,
Could you post configuration from the x-lite softphone?
Best regards,
Alex
01-23-2012 02:26 PM
Here you are:
01-25-2012 02:11 PM
Are you using the same network settings on the PC and the phone? Could you post some debugs from the phone?
Best regards,
Alex
01-26-2012 02:21 PM
Sorry, I have not debug from phone. Network config - the same absolutly. Both placed on the same network.
BR/Andrey
01-26-2012 03:08 PM
The line is disabled in your screen shot - was this intentional ?
02-03-2012 12:54 AM
not, is not a case. Line was down before I have made screenshort but ofcaurse up when have been testing.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide