01-21-2012 02:54 PM - edited 03-21-2019 05:13 AM
Hello,
The problem is when we try to register Cisco SPA525G2 softswitch TSIP, we get the message: "407 Proxy Authentication Required"
Sombody could advise how to configure 525G2 to send proxy auth.?
Thank you very much.
Andrey
01-21-2012 04:52 PM
Hi,
Please check the credentials you have entered.
You can see the proxy settings uder the extension tab on web interface of the phone.
Best regards,
Alex
*Please rate helpful posts
01-21-2012 05:37 PM
01-22-2012 02:50 AM
Hi,
You are already sending the proxy authentication. Check the settings on the server and if the proxy is correct, also the username and the password.
Best regards,
Alex
01-22-2012 03:18 AM
Hi,
I saw the traffic by wireshark. No proxy-authorization/authentification sentence in SIP header. See screenshort one from 525G2 other from Softphone. With softphone registration is ok.
01-22-2012 03:19 AM
the difference is obvious. 525G2 does not sent proxy-auth. clause.
01-23-2012 02:19 PM
Hi,
Could you post configuration from the x-lite softphone?
Best regards,
Alex
01-23-2012 02:26 PM
Here you are:
01-25-2012 02:11 PM
Are you using the same network settings on the PC and the phone? Could you post some debugs from the phone?
Best regards,
Alex
01-26-2012 02:21 PM
Sorry, I have not debug from phone. Network config - the same absolutly. Both placed on the same network.
BR/Andrey
01-26-2012 03:08 PM
The line is disabled in your screen shot - was this intentional ?
02-03-2012 12:54 AM
not, is not a case. Line was down before I have made screenshort but ofcaurse up when have been testing.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: