×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Adding 1 to all outgoing calls

Unanswered Question
Feb 2nd, 2012
User Badges:

I have recently set up a new SIP provider on a UC560 that requires all numbers be 11-digit numbers starting with a 1. Is there any good way to have an outgoing dial-peer to translate all numbers dialed without 1 to add a 1 and the same time if someone does add a 1 a to the number they are dialing that system will treat it normally?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Mario Garcia Thu, 02/02/2012 - 18:51
User Badges:

Via CLI you can in the dial-peer to prefix a 1


Sent from Cisco Technical Support iPhone App

pennautomotive Thu, 02/02/2012 - 18:55
User Badges:

Do you mind providing an example? Even sudo-code would be appreciated.

Mario Garcia Thu, 02/02/2012 - 19:02
User Badges:

Basically gain access via CLI


Located the dial-peer, commands as follows when in enable mode


Conf t

Dial-peer voice XX pots

Prefix 1

End


"XX" is the dial peer number you want to edit.


Let me know if you need additional commands


-Mario




Sent from Cisco Technical Support iPhone App

Actions

This Discussion