02-02-2012 03:29 PM - edited 03-21-2019 05:17 AM
I have recently set up a new SIP provider on a UC560 that requires all numbers be 11-digit numbers starting with a 1. Is there any good way to have an outgoing dial-peer to translate all numbers dialed without 1 to add a 1 and the same time if someone does add a 1 a to the number they are dialing that system will treat it normally?
02-02-2012 06:51 PM
Via CLI you can in the dial-peer to prefix a 1
Sent from Cisco Technical Support iPhone App
02-02-2012 06:55 PM
Do you mind providing an example? Even sudo-code would be appreciated.
02-02-2012 07:02 PM
Basically gain access via CLI
Located the dial-peer, commands as follows when in enable mode
Conf t
Dial-peer voice XX pots
Prefix 1
End
"XX" is the dial peer number you want to edit.
Let me know if you need additional commands
-Mario
Sent from Cisco Technical Support iPhone App
02-02-2012 07:03 PM
That's perfect. Thank you very much.
Sent from my iPhone
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide