×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Issues with Cisco PIX 515e

Unanswered Question
Feb 9th, 2012
User Badges:

So, i am trying just to do the initial setup of a Cisco PIX515e 6.3, and I am hitting a brick wall.


I got the console up, thought that I had everything configured correctly  (Like internal IP and such), but I can't ping to or from, with a  crossover cable from inside/ethernet0 to a PC.

Need some help/advise.

I would also like to get it set up for management via ASDM.


It is a base config, nothing else.


Thanks

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
nagel Thu, 02/09/2012 - 09:47
User Badges:

Typically Inside is Ethernet1 but anyway - I think you need straight cable from inside to PC not xover and then obviously the 6 commands


Nameif

Interface

IP Address

Nat

Global

Route


sh xlate will indicate whether or not your translation is working Nat/Global

sh int will let you know whether your Interfaces are configured correctly


Need to be sure you have different network on each side (inside. outside)


Inside Security = 100

Outside Security = 0


You wont be able to ping to the pix but you should be able to ping from the pix (next hop router, pc, etc)

Actions

This Discussion