C2960 password-recovery status show command

Unanswered Question
Feb 10th, 2012
User Badges:
  • Bronze, 100 points or more

Ok, so I enabled the "no service password-recovery" command on my C2960 switch.

All seems to work as discribed.

Only issue I have is --- which show command is used to reveal if the password-recovery feature is enabled of disabled as the command doesn't show up in the running config after you enable it ?

:

NOTE:

The command does show up in the C2960 switch in config t mode (unlike the IOS router 2800 series), but doesn't show up in the running-config after you enable or disable it.


On the 2800 series routers (latest IOS) in config t mode the command does not show up but if you type "no service passowrd-recovery" the command function correctly and it does list it in the running configuration. Strange!

:

Tks

Frank

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Leo Laohoo Fri, 02/10/2012 - 13:37
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 LAN, Wireless

sh version

sh run

Actions

This Discussion