Access Server - connecting to s1 but no cli

Unanswered Question
Feb 11th, 2012

I am currently setting up an access server and can now connect to my switch1 but getting a blank screen and no cli.

i use the ctrl shift 6 -x and can return to AS but never getting anything to perform commands on SW1.

am i missing something here????

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Derek Cameron Sat, 02/11/2012 - 06:09

Using 892 out of 32762 bytes

!

version 11.2

no service password-encryption

service udp-small-servers

service tcp-small-servers

!

hostname AccessServer

!

enable secret 5 $1$NDeh$b9kPnpDsGgR5mvkYFMFTo.

!

partition flash 2 8 8

!

ip host S1 2001 10.10.10.10

ip host S2 2002 10.10.10.10

ip host R1 2003 10.10.10.10

ip host R2 2004 10.10.10.10

ip host R3 2005 10.10.10.10

!

interface Ethernet0

no ip address

no ip route-cache

no ip mroute-cache

!

interface Serial0

no ip address

no ip route-cache

no ip mroute-cache

shutdown

no fair-queue

!

interface Serial1

no ip address

no ip route-cache

no ip mroute-cache

shutdown

!

no ip classless

!

line con 0

exec-timeout 0 0

password cisco

logging synchronous

login

line 1 8

no exec

exec-timeout 0 0

transport input telnet

line aux 0

transport input all

line vty 0 4

login

!

end

Derek Cameron Sat, 02/11/2012 - 06:58

I think I have finally sorted it out.

My cables are numbered from 0 - 7 and I was using 1 - 5 and not able to connect to s1 which should of had cable 0.

Seems logical now.

Thanks anyway

Actions

This Discussion