02-11-2012 03:16 AM - edited 03-07-2019 04:52 AM
I am currently setting up an access server and can now connect to my switch1 but getting a blank screen and no cli.
i use the ctrl shift 6 -x and can return to AS but never getting anything to perform commands on SW1.
am i missing something here????
02-11-2012 04:15 AM
post your config
Sent from Cisco Technical Support iPad App
02-11-2012 06:09 AM
Using 892 out of 32762 bytes
!
version 11.2
no service password-encryption
service udp-small-servers
service tcp-small-servers
!
hostname AccessServer
!
enable secret 5 $1$NDeh$b9kPnpDsGgR5mvkYFMFTo.
!
partition flash 2 8 8
!
ip host S1 2001 10.10.10.10
ip host S2 2002 10.10.10.10
ip host R1 2003 10.10.10.10
ip host R2 2004 10.10.10.10
ip host R3 2005 10.10.10.10
!
interface Ethernet0
no ip address
no ip route-cache
no ip mroute-cache
!
interface Serial0
no ip address
no ip route-cache
no ip mroute-cache
shutdown
no fair-queue
!
interface Serial1
no ip address
no ip route-cache
no ip mroute-cache
shutdown
!
no ip classless
!
line con 0
exec-timeout 0 0
password cisco
logging synchronous
login
line 1 8
no exec
exec-timeout 0 0
transport input telnet
line aux 0
transport input all
line vty 0 4
login
!
end
02-11-2012 06:58 AM
I think I have finally sorted it out.
My cables are numbered from 0 - 7 and I was using 1 - 5 and not able to connect to s1 which should of had cable 0.
Seems logical now.
Thanks anyway
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide