Buy or Renew
Buy or Renew
Cisco Virtual Engineer generative AI bot now active in Wireless Discussion Forum. Learn more.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
474
Views
0
Helpful
3
Replies

Cisco 1522 - getting radios enabled

burnsidestev
Level 1
Level 1

‎02-14-2012 12:16 PM - edited ‎07-03-2021 09:35 PM

I have added the AP to the mac filter list, so I can see it in the controller

The b/g antennas are 5dBi so I set it to 10 x .5

the a antennas are 8 dBi so I set them to 16 x .5

I am not able to get the radios to come online.  Is there something I am missing?

Labels:
0 Helpful
3 Replies 3

Stephen Rodriguez
Cisco Employee
Cisco Employee

‎02-14-2012 12:24 PM

Is the B/G and the A/N networks enabled globally?

Steve

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered
0 Helpful

burnsidestev
Level 1
Level 1
In response to Stephen Rodriguez

‎02-14-2012 12:57 PM

Yes,

this controller has 3500 series APs on it as well that are all functioning.  it is on code 7.0.116.0.

0 Helpful

burnsidestev
Level 1
Level 1
In response to burnsidestev

‎02-14-2012 02:32 PM

I figured out the issue.  I had it connected to a PoE+ switch.  it was enough power to boot, but not power the radios.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card