Unanswered Question
Feb 15th, 2012
User Badges:


I went through below link


I have the same setup except the dhcp.

I have dhcp server which is givng IP to clients; I want to divide clients as bulding 1 and building 2 with vlan

But they should get IP from same dhcp server

how can I do it?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
nikhilcherian Wed, 02/15/2012 - 23:39
User Badges:
  • Bronze, 100 points or more

Have you created ap-group per building and did interface over-ride



nikhilcherian Thu, 02/16/2012 - 00:58
User Badges:
  • Bronze, 100 points or more

Configure it like this

Create AP-Groups in the WLC for each of the building

Create dynamic interfaces for each building

Under WLAN>Ap-Groups, add each AP in each building, in the respective AP-Groups

Map the WLAN to the AP-groups to the interface for each building ( you can see an option, Add interface mapping in the document you sent)



vishalpatil86 Thu, 02/16/2012 - 01:32
User Badges:

what about the vlan,

i need to configure vlan 4000 and 4001

first buldng aps will be in vlan 4000 and second bldng will be in 4001

right now i have only 4001 enabled

nikhilcherian Thu, 02/16/2012 - 01:37
User Badges:
  • Bronze, 100 points or more

Create VLAN 4000 also and configure the AP port in VLAN 4000. If you want the client to get ip address in vlan 4000, create a dynamic interface in the WLC in vlan 4000 and map it to the WLAN




This Discussion