×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Secondary dial tone same as primary tone CUCM v7.X

Unanswered Question
Feb 17th, 2012
User Badges:

Hi all.


We have discovered that our secondary dial tone is the same as our primary dial tone. All route patterns set for call classification offnet and box ticked for outside dial tone. The service parameter Call Classification is set to OFFNet, and all gateways are set to use that system default.

Any thoughts appreciated.


R.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Chris Deren Fri, 02/17/2012 - 06:17
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,
  • Cisco Designated VIP,

    2017 IP Telephony, Contact Center, Unified Communications

Take a look at what this parameter is set to, perhaps it was changed to "Inside":


Always Use Dial Tone Setting: This parameter determines whether Cisco CallManager should always play default/inside/outside dial tone.
Default -- Outside dial tone can differ from inside dial tone.
Inside -- Always play inside dial tone, even for calls that are destined for OffNet (no distinction between inside and outside dial tone).
Outside -- Always play outside dial tone, even for calls that are destined for OnNet (no distinction between inside and outside dial tone).
   This is a required field.   Default:  Default   


HTH,


Chris

rfawns Fri, 02/17/2012 - 07:13
User Badges:

Hi Chris,


Thanks for the reply.

I had checked that and it is set for default..


Rod

Chris Deren Fri, 02/17/2012 - 07:15
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,
  • Cisco Designated VIP,

    2017 IP Telephony, Contact Center, Unified Communications

So, you go off hook you hear a dial-tone, you enter off-net access code (i.e. 9) the dial same dial tone continutes to play?

Are all your route patterns, xlation patters, etc that start with the off-net access code configured with "provide outside dial tone"?


Chris

rfawns Fri, 02/17/2012 - 07:49
User Badges:

Yep,

It only became apparent, because someone had created UDP's starting 9 and the dialtone came in after the second digit was pressed. once they were removed, we noticed it was a continuous tone.


Rod

Actions

This Discussion