SCH Transport Gateway

Unanswered Question
Feb 22nd, 2012

Hi Pro´s!

I ran into some problems installing the Transport Gateway for Cisco Smart Call Home. I downloaded the latest package for Windows and ran it on a Server 2003 SP2. The installation went on without any errors and I clicked on the Finish button and the application closed down. Now - when i press att the GUI icon och the desktop nothing happens!  I checked that the service was running, I stopped the service and turnt it on again, but nothing changed.
I´ve read the installation manual and it doesn´t mention anything special, just start the GUI and go on with the registration.

Has any of you any ideas what I should do?

Best regards

Johan

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Average Rating: 0 (0 ratings)
jmandersson Wed, 02/22/2012 - 22:19

An update,

I found the answer in Troubleshooting and Support guide:
following steps:
Stop the TG service
Close the RDP Connections
Re-launch the RDP using the following command

mstsc /v /admin
Launch the Transport Gateway.


That, togheter with http://blogs.msdn.com/b/rds/archive/2007/12/17/changes-to-remote-administration-in-windows-server-2008.aspx where the complete solution.
Chers,
Johan

Actions

Login or Register to take actions

This Discussion

Posted February 22, 2012 at 10:06 AM
Stats:
Replies:1 Avg. Rating:
Views:425 Votes:0
Shares:0

Related Content

Discussions Leaderboard