cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
696
Views
0
Helpful
5
Replies

External Parties Not Getting Ring Back Tone

mohammednoor
Level 1
Level 1

Hi,

I have a issue whereby external calling parties to analog phones are not getting a ring back tone; no issues with internal calls. No issues with the IP phones as well.

The PBX is running on Cisco 2951 and CME version 7.1.

Any information would be very much appreciated. Thanks.

Regards,

M Noor

5 Replies 5

boris.kudr
Level 1
Level 1

Hi Mohammed,

Please post dial-peers and "debug isdn q931" for incoming calls from PSTN.

Most likely you would be able to fix the issue by adding "tone ringback alert-no-PI" into incoming POTS dial-peer.

Cheers,

Boris

_____ Please rate helpful posts Пожалуйста оценивайте полезные сообщения

ADAM CRISP
Level 4
Level 4

Hi,

You could try the global command "voice call send-alert" which changes slightly the ISDN ringback messages sent to the ISDN telco.

Adam

Here's the Cisco doc that usually explains this issue:

http://www.cisco.com/en/US/tech/tk1077/technologies_tech_note09186a0080094c33.shtml

Hi Adam,

Thanks for the information. I had scheduled to isolate the issue this afternoon and the global command worked like a charm.

Regards,

M Noor

Good. I am glad this saved you some time.

Adam

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: