×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

LMS 4.0 Fault Management Module alert doesn't show CurrentUtilization

Unanswered Question
Feb 23rd, 2012
User Badges:

Hi,

I would like to know if there's a way to show CurrentUtilization percentage within the messages generated by the Fault Management Module in LMS 4.0


EVENT ID                = 00008Z1

TIME                    = S

STATUS                  = Active

SEVERITY                = Critical

MANAGED OBJECT          = switch

MANAGED OBJECT TYPE     = Switches and Hubs

EVENT DESCRIPTION       = HighUtilization::Component=PORT-switch/11150 [Gi3/0/50] [---> TRUNK ];ComponentClass=Port;ComponentEventCode=1057;TrafficRate=5.2261432E7  BYPS;DuplexMode=FULLDUPLEX;UtilizationThreshold=40;MaxSpeed=1000000000;Type

NOTIFICATION ORIGINATOR = Fault Management Module


As you can see above CurrentUtilization percentage is not shown in Event Description section.


Could someone help?


Thank you!


Massimiliano.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Michel Hegeraat Thu, 02/23/2012 - 06:45
User Badges:
  • Gold, 750 points or more

To my knowledge nothing can be configured here.


You have to take traffic rate and max speed and do the calculation yourself


FAD! functioning as designed


Cheers,


Michel

Massimiliano Moresi Thu, 02/23/2012 - 07:20
User Badges:

Hi Michel,

thanks for your reply. It was my suspicious!   


Maybe someone else can enlighten us.

Or at least let us know  if the CurrentUtilization percentage counter will come with  future  release/patch.


Ciao,

Massimiliano

Actions

This Discussion