×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

WLC 2504 and HP switch port settings

Unanswered Question
Feb 24th, 2012
User Badges:

Hi,



I'm having some problems configuring a 2504 wlc and a couple of APs (1131) connected to a HP ProCurve switch. I would appreciate any input as I do not have any experience with HP ProCurve switches.



The WLC port1 are connected to HP switch with vlan1, vlan11 and vlan66 TAGGED (trunk).

Same vlans are tagged on AP ports connected to same HP switch.

Result: AP does not show in WLC



If I set UNTAGGED (access) instead, the APs shows in the WLC. The problem is that I need to use several vlans and ssid's



Interfaces:

mgmt -> HP switch

10.1.7.15



internal-vlan11 -> SSID: CONTOSO

10.1.11.2



guest-vlan66 -> SSID: CONTOSOGUEST

10.1.20.2



My question is, what's the correct setting on the HP switch?


Appreciate any help!

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Stephen Rodriguez Fri, 02/24/2012 - 04:44
User Badges:
  • Purple, 4500 points or more

For the AP that access should be correct. If the ap is in local mode all the traffic will backhaul ti the WLC.


Steve


Sent from Cisco Technical Support iPhone App

Actions

This Discussion