Profile 42c20 to Profile 42c20

Answered Question
Feb 24th, 2012

I just wanted to verify that it's possible to do a point to point call between two profile 42c20 units without a VCS or CUCM. They are connected via a WAN so it's just IP to IP correct?

Also, the SX20 quick set that is capable of multiway can do a multipoint call with 3 additional units without an MCU.Is that a correct statement ?

Thanks

I have this problem too.
0 votes
Correct Answer by Robert Krenn about 3 years 5 months ago

Yes that is correct.

Remember that the default configuration supplied with a Cisco C20 or SX20 will require a Gatekeeper. So you need to turn that off first. Otherwise your call attempts will fail.

//Robert

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Correct Answer
Robert Krenn Fri, 02/24/2012 - 06:00

Yes that is correct.

Remember that the default configuration supplied with a Cisco C20 or SX20 will require a Gatekeeper. So you need to turn that off first. Otherwise your call attempts will fail.

//Robert

Actions

This Discussion