Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
1094
Views
0
Helpful
3
Replies

Etherchannel issue with netapp

Tony MALPASS
Level 1
Level 1

‎02-27-2012 12:49 AM - edited ‎03-07-2019 05:12 AM

Hi

I have an etherchannel configured on a cat6k to connect to a netapp. the ints in the channel group are up but the port channel is down. when i do a show etherchannel summary it show that the ports are in portchannel 12A not 12. Any ideas

the config is attached.

Labels:
123360-pnz.txt.zip
0 Helpful
3 Replies 3

acampbell
VIP Alumni
VIP Alumni

‎02-27-2012 03:37 AM

Hi,

Looking at this link seems to infer that there is some difference between the 2 physical ports.

http://www.cisco.com/en/US/tech/tk389/tk213/technologies_configuration_example09186a0080094470.shtml#po1a

I do not see what is is.

May be show interface might point to the issue

A second prt channel xxA is created by lacp when discrepencies are found in the original xx channel group

Regards

Alex

Regards, Alex. Please rate useful posts.
0 Helpful

Marcel Zehnder
Spotlight
Spotlight

‎02-27-2012 09:26 AM

In addition check the version of the netapp device - Last week I had similar issues with a netapp device. The solution was a software upgrade on the netapp-filer.

regards

Marcel

0 Helpful

Devavrat Oka
Level 1
Level 1

‎05-23-2012 11:58 AM

Can you paste an ifconfig -a output from the netapp controller here?

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card