Etherchannel issue with netapp

Tony MALPASS · ‎02-27-2012

Hi

I have an etherchannel configured on a cat6k to connect to a netapp. the ints in the channel group are up but the port channel is down. when i do a show etherchannel summary it show that the ports are in portchannel 12A not 12. Any ideas

the config is attached.

acampbell · ‎02-27-2012

Hi,

Looking at this link seems to infer that there is some difference between the 2 physical ports.

http://www.cisco.com/en/US/tech/tk389/tk213/technologies_configuration_example09186a0080094470.shtml#po1a

I do not see what is is.

May be show interface might point to the issue

A second prt channel xxA is created by lacp when discrepencies are found in the original xx channel group

Regards

Alex

Regards, Alex. Please rate useful posts.

Marcel Zehnder · ‎02-27-2012

In addition check the version of the netapp device - Last week I had similar issues with a netapp device. The solution was a software upgrade on the netapp-filer.

regards

Marcel

Devavrat Oka · ‎05-23-2012

Can you paste an ifconfig -a output from the netapp controller here?