02-28-2012 07:46 PM - edited 03-07-2019 05:15 AM
On a 4500 switch having a single sup engine, another sup engine was installed to act as redundant one.
the redundancy mode was changed to sso, thereafter the secondary sup was prompted to be reset.
After it came back up again, the redundancy status still shows as RPR in operation mode.
why is it so and what should be done to make sure that sso works ?
02-29-2012 12:28 AM
I believe there are different version of IOS running on the SUP engines. Make sure, they are same. Though being in RPR mode works, but incase if you primary SUP failed due to some reason, then the standby done has to boot in order to take up.
Thanks
Vivek
02-29-2012 05:28 AM
thanks Vivek. I had verified the IOS on both engines to be the same, as the image was copied to the slave sup.
03-02-2012 12:22 PM
You need to make sure you have the same hardware on both superivors, for example the same ram. Another fact to keep in mind is to have the ios on both supervisors on the same memory. So for example on the active you have it on bootflash then on the slave you must have it on bootflash as well. You can verify the boot statement with a show bootv
Sent from Cisco Technical Support iPhone App
03-03-2012 07:12 AM
Thanks Diego. I see memory mismatch between the sup's.
"Main memory mismatch. Active supervisor has 1048576K memory. Standby supervisor has 524288K memory. Redundancy feature may not work as expected."
does this contribute to the fact that sso doesn't function even though it is configured for. below is the redundancy output:
Redundancy Mode (Operational) = rpr
Redundancy Mode (Configured) = sso
Redundancy State = rpr
if memory is causing the problem, what memory is it referring to, the onboard flash memory on each individual sup?
thanks again.
03-03-2012 08:26 AM
Yes, the message is referring to DRAM. In order for SSO to work correctly, you need the same exact components in each Sup.
HTH
03-03-2012 08:59 AM
Thanks Reza.
Can we replace the RAM chip simply on the supervisor engines or has the sup engine to be replaced totally & new one ordered with a required memory.
Thanks again!
03-03-2012 09:06 AM
Can you provide the model number?
Sent from Cisco Technical Support iPhone App
03-03-2012 09:29 AM
the sup model is WS-X45-SUP6-E
thanks.
03-03-2012 09:43 AM
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: