we just received 5 new 8945 phones and I want to use the G722 codec on them, the question is where can I get this from or does it come installed with CM already. And if it's already on CM where do I go to check and make it the default.
You set wheter to advertise/use it at the service parameter level and device level.
|G.722 Codec Enabled:||This parameter determines whether Cisco Unified Communications Manager allows G.722 negotiation for all, some, or no devices. Valid values specify Enabled for All Devices, Enabled for All Devices Except Recording-Enabled Devices, or Disabled.|
|This is a required field.|
|Default: Enabled for All Devices|
On device: Advertise G.722 Codec
If this helps, please rate