I encountered again a problem with the new virtual appliance of Cisco Prime LMS 4.1.
My appliance is installed, licence embedded, and several devices added into the DCR.
If I'm going on the Inventory > Manage Device State, I can find ALL my added devices (I use hostname, without appending DNS domain).
But into the Campus Manager , for example into : Configuration > Workflows > VLAN > Port Vlan Assignment , I don't have any devices in !
Well, I tried many times to Run a Data Collection on "All Devices", but nothing more...
If I go to Admin > Collection Settings > Data Collection --> Show Devices --> Always the same devices into it ... nearly 20 devices, and I have much more than 20 devices into my network !!
How could I solve this issue please ?
It 's really annoying, because we cannot manage PORT VLAN ASSIGNMENT from LMS on the devices...
Thank a lot for your answer.
When the devices don't get 'data collected' they will just not appear there
Nothing under (VTP) domain selector either then?
Not sure what could cause this. I think a problem with the ani db.
You can reinit or do a dbrestoreorig. See the forum documents for details