03-09-2012 03:44 PM - edited 03-07-2019 05:28 AM
Is there any question with hardware about the WS-X4612-SFP-E modle.thanks
Solved! Go to Solution.
03-09-2012 04:27 PM
is there any question about "config-register = 0x2101".thanks.
No.
Cisco IOS Software, Catalyst 4500 L3 Switch Software (cat4500e-IPBASE-M), Version 12.2(53)SG4, RELEASE SOFTWARE (fc2)
Your IOS does NOT support the WS-X4612-SFP-E line card. Upgrade to 12.2(54)SG or later.
03-09-2012 11:01 PM
If the solution works, can I request if you can mark this thread as "Answered" please?
03-09-2012 03:50 PM
C'mon, mate. You need to give us more info than this!
You need a minimum of Cisco IOS Software Release 12.2(54)SG or later.
03-09-2012 04:02 PM
**********************************************************
* *
* Welcome to Rom Monitor for WS-X45-SUP6L-E System *
* Copyright (c) 2003-2011 by Cisco Systems, Inc. *
* All rights reserved. *
* *
**********************************************************
Checking the partition table and boot sector...
Checking FAT, Files and Directories...
Reclaiming unused space...
Updating FAT...
Rom Monitor Program Version 12.2(44r)SG10
CPU Rev: 2.1, Board Rev: 12, Board Type: 103, CPLD Nexu Rev: 14
Chassis: WS-C4506-E
Front Panel Phy is Bcm5482s
Got Mac Address: 30:e4:db:fd:ac:e1
MAC Address : 30-e4-db-fd-ac-e1
Ip Address : Not set.
Netmask : Not set.
Gateway : Not set.
TftpServer : Not set.
Peer supervisor not detected or is not running IOS
Supervisor uplinks and all linecards have been reset
***** The system will autoboot in 5 seconds *****
Type control-C to prevent autobooting.
. . . . .
******** The system will autoboot now ********
config-register = 0x2101
Autobooting using the first file from bootflash.....
sho ver
Cisco IOS Software, Catalyst 4500 L3 Switch Software (cat4500e-IPBASE-M), Version 12.2(53)SG4, RELEASE SOFTWARE (fc2)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2011 by Cisco Systems, Inc.
Compiled Fri 25-Feb-11 15:14 by prod_rel_team
Image text-base: 0x10000000, data-base: 0x124334BC
ROM: 12.2(44r)SG10
Darkside Revision 4, Jawa Revision 14, Tatooine Revision 140, Forerunner Revision 1.21
Switch uptime is 1 minute
System returned to ROM by power-on
System image file is "bootflash:cat4500e-ipbase-mz.122-53.SG4.bin"
cisco WS-C4506-E (MPC8548) processor (revision 12) with 524288K bytes of memory.
Processor board ID SPE152800QF
MPC8548 CPU at 1GHz, Supervisor 6L-E
Last reset from PowerUp
1 Virtual Ethernet interface
52 Gigabit Ethernet interfaces
2 Ten Gigabit Ethernet interfaces
511K bytes of non-volatile configuration memory.
--More--
--More-- Configuration register is 0x2101
sho mod
Chassis Type : WS-C4506-E
Power consumed by backplane : 0 Watts
Mod Ports Card Type Model Serial No.
---+-----+--------------------------------------+------------------+-----------
1 6 Sup 6L-E 10GE (X2), 1000BaseX (SFP) WS-X45-SUP6L-E JAE15300DRW
3 48 10/100/1000BaseT (RJ45) WS-X4648-RJ45-E JAE153805FF
5 0 Unsupported module WS-X4612-SFP-E JAE15330C0I
M MAC addresses Hw Fw Sw Status
--+--------------------------------+---+------------+----------------+---------
1 30e4.db27.e840 to 30e4.db27.e845 3.0 12.2(44r)SG1 12.2(53)SG4 Ok
3 ccef.483a.c89c to ccef.483a.c8cb 1.0 Ok
5 7081.0556.0fa0 to 7081.0556.0fab 1.1 Unsupport
03-09-2012 04:03 PM
is there any question about "config-register = 0x2101".thanks.
03-09-2012 04:27 PM
is there any question about "config-register = 0x2101".thanks.
No.
Cisco IOS Software, Catalyst 4500 L3 Switch Software (cat4500e-IPBASE-M), Version 12.2(53)SG4, RELEASE SOFTWARE (fc2)
Your IOS does NOT support the WS-X4612-SFP-E line card. Upgrade to 12.2(54)SG or later.
03-09-2012 05:07 PM
thanks,i'll try.
03-09-2012 11:01 PM
If the solution works, can I request if you can mark this thread as "Answered" please?
03-10-2012 01:06 AM
ok,thanks!
03-10-2012 01:46 AM
Cool! I'm happy to see the solution works.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide