×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

c-barge , no. of users

Unanswered Question
Mar 15th, 2012
User Badges:
  • Cisco Employee,

Hi All,



Hope you are doing well.


I have a query , from what i know , we can have more than one user who can c-barge on an active call . To do the same i think we have a Shared Bridge, but when i check the same on the device page to configure for the user i do not seem to find the option, other than a built in bridge, would really appreciate if some body can guide me the exact steps where we can enable the shared bridge to allow more than 1 users to get to c-barge as , as of now , only the user on call can get to barge, and more than that a limit exceed message comes up.


Would appreciate the help.



Regards,


Abhishek

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Jaime Valencia Thu, 03/15/2012 - 08:52
User Badges:
  • Cisco Employee,
  • Hall of Fame,

    2011

c-barge uses a conference bridge and not the bulit-in bridge as barge does.

Check same stuff as if you were having a conference problem.


HTH


java


If this helps, please rate


www.cisco.com/go/pdihelpdesk

Chris Deren Thu, 03/15/2012 - 08:58
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,
  • Cisco Designated VIP,

    2017 IP Telephony, Contact Center, Unified Communications

Are you using the cBarge feature, that supports multiple second barge in call.  You need to make sure you have conference bridges available for that and that the cBarge softkey is added to the phone. Checkout Cisco CUCM Feature guide for deails.


HTH,


Chris

Abhishek Singh Thu, 03/15/2012 - 23:26
User Badges:
  • Cisco Employee,

Hi Chris,


Yes  , was using cBarge, and that too on a shared line, where more than 10 users have to be logged in. My knoweldgeable colleague helped on that part of Barging.



I have increased the max calls on all the device having that specific extension ( or line ) to be 10 be to be precise , apart from enabling all the necessary c-Barge features.


Hope it should work now . 

Actions

This Discussion

Related Content