CUCM - Two SIP Trunk with Same Destination

Unanswered Question
Mar 20th, 2012

Hi ,

We configure the  Two SIP trunk with Service Provider.One is for G711u codec another one for G729 codec.

There is no issue in the Outbound calls.

We have the problem in Incoming calls when the Service Provider send the call with g711 codec ccm select g729 trunk always.

Any one can explain the Incoming call behaviour for this scneario with any refernce document.

Thank

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Average Rating: 0 (0 ratings)
gapande Tue, 03/20/2012 - 00:12

Sriram,

To understand better, could you explain the call flow ? i.e. where the call comes from & where it goes ?

GP.

gpsriramdc Tue, 03/20/2012 - 00:16

Hi ,

Call flow will be

Remote Site   ---> SBC ---> CUBE ---> CUCM    ( CUBE to CUCM two SIP trunks)

Jonathan Schulenberg Tue, 03/20/2012 - 03:29

CUCM will choose the SIP trunk based on the IP address in the FROM/VIA header of the SIP INVITE. Be sure that you are binding the outbound VoIP dial-peers on CUBE to separate loopback interfaces to allow CUCM to tell the difference.

Also be sure that the two SIP trunks in CUCM have different regions assigned and that your region matrix is properly configured to use a 64kbps codec with everything to/from that region.

Actions

Login or Register to take actions

This Discussion

Posted March 20, 2012 at 12:01 AM
Stats:
Replies:3 Avg. Rating:
Views:228 Votes:0
Shares:0
Tags: No tags.

Discussions Leaderboard

Rank Username Points
1 21,026
2 15,047
3 10,314
4 7,999
5 4,856
Rank Username Points
154
95
75
66
55