ā03-20-2012 12:01 AM - edited ā03-16-2019 10:12 AM
Hi ,
We configure the Two SIP trunk with Service Provider.One is for G711u codec another one for G729 codec.
There is no issue in the Outbound calls.
We have the problem in Incoming calls when the Service Provider send the call with g711 codec ccm select g729 trunk always.
Any one can explain the Incoming call behaviour for this scneario with any refernce document.
Thank
ā03-20-2012 12:12 AM
Sriram,
To understand better, could you explain the call flow ? i.e. where the call comes from & where it goes ?
GP.
ā03-20-2012 12:16 AM
Hi ,
Call flow will be
Remote Site ---> SBC ---> CUBE ---> CUCM ( CUBE to CUCM two SIP trunks)
ā03-20-2012 03:29 AM
CUCM will choose the SIP trunk based on the IP address in the FROM/VIA header of the SIP INVITE. Be sure that you are binding the outbound VoIP dial-peers on CUBE to separate loopback interfaces to allow CUCM to tell the difference.
Also be sure that the two SIP trunks in CUCM have different regions assigned and that your region matrix is properly configured to use a 64kbps codec with everything to/from that region.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: