03-21-2012 08:53 PM - edited 03-11-2019 03:45 PM
Got new ASA5550, code 8.2.2 in flash, can't configure "nameif" or "ip address" on the interfaces:
ciscoasa(config)# int gig0/0
ciscoasa(config-if)# ?
Interface configuration commands:
default Set a command to its defaults
description Interface specific description
dhcp Configure parameters for DHCP client
duplex Configure duplex operation
exit Exit from interface configuration mode
help Interactive help for interface subcommands
no Negate a command or set its defaults
shutdown Shutdown the selected interface
speed Configure speed operation
These are all the options that I get! Another weird thing I noticed is "<system>" string in "show ver" top line:
ciscoasa# sh ver
Cisco Adaptive Security Appliance Software Version 8.2(2) <system>
Compiled on Mon 11-Jan-10 14:19 by builders
System image file is "disk0:/asa822-k8.bin"
Config file at boot was "startup-config"
ciscoasa up 27 mins 22 secs
Hardware: ASA5550, 4096 MB RAM, CPU Pentium 4 3000 MHz
Internal ATA Compact Flash, 256MB
BIOS Flash M50FW080 @ 0xffe00000, 1024KB
Has anyone seen this before?
Solved! Go to Solution.
03-22-2012 12:04 AM
That ASA is in multiple context mode.
03-22-2012 12:04 AM
That ASA is in multiple context mode.
03-22-2012 08:45 AM
You just made me feel like an idiot! Thanks a lot!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: