cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2372
Views
11
Helpful
8
Replies

Analog Conference Station on VG224 unable to hold and conference

abraham1982
Level 1
Level 1

Hello All,

My customer has 3 analog conference stations

ClearOne Max EX wired

Polycom Voicestation 300

Polycom Soundstation VTX 1000

These are connected to a VG224, added to the CUCM. for conferencing, Users should ideally place the first call on hold and then dial the 3rd number and conference. Users are unable to place the first call on hold and then dial a second number and then put the two dialled calls in conference.

Please provide some suggestions to troubleshoot this.

Regards

Abraham

8 Replies 8

kelvin.blair
Level 5
Level 5

Abraham,

Your VG224 will need to be setup as a SCCP gateway to CUCM.  Once you done this, please be sure to have this command in the system. 

"stcapp call-control mode standard"

This will enable hookflash to work with conference phones.

cheers!

KB

Thanks a lot for your reply Kelvin.

In the VG224, this was the configuration

stcapp ccm-group 1

stcapp

!

stcapp feature access-code

I have added the command stcapp call-control mode standard under config t  but now when I do a show run I cannot see this command applied anywhere.

Am I missing something ?

Thanks

Abraham

Just means that it is enabled in the default router configuration and only doing a "no" will make it appear in the configuration. 

add "stcapp supplementary-services" command

cheers!

KB

thomas-jensen
Level 1
Level 1

I'm running IOS 15.1 and these could be some more helpful commands.

stcapp supplementary-services

port 2/0

  hold-resume

voice-port 2/0

timeouts initial 60

timeouts interdigit 60

timeouts call-disconnect 0

timeouts ringing infinity

timeouts power-denial 2000

caller-id enable

Thanks again for the reply.

To add the command stcapp supplementary-services, I believe I have to get in to the ccm-group. But it is not allowing me to.

(config)#stcapp ccm-group 1

stcapp is running... unable to change ccm-group

Is there any other way to apply this command.

Regards,

Abraham

Anyone has any idea how to apply the command stcapp supplementary-service in VG224. For me it gives the error

(config)#stcapp ccm-group 1

stcapp is running... unable to change ccm-group

or If I try

(config)#stcapp supplementary-services

It is unrecognized..

Please help.

Abraham

thomas-jensen
Level 1
Level 1

Try this

-vg08(config)#no stcapp

stcapp shutdown initiated... waiting for calls to clear.

stcapp shutdown complete.

vg08(config)#stcapp ccm-group 2

vg08(config)#stcapp ccm-group 1

-vg08(config)#stcapp

(config)#stcapp

Thanks a ton guys.

Abraham

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: