Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.


Unanswered Question
Mar 29th, 2012
User Badges:

Dear All,

I want to configure DID on E1 PRI

I configured the PRI as follows and I need help to configure the DID on it.

isdn switch-type < primary-net5 >

controller e1 0/2/0

framing <crc4>

linecode < hdb3 >

pri-group timeslots < 1-31 >

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
paolo bevilacqua Thu, 03/29/2012 - 03:45
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Have you ever configured voice before? Do you know about things like dial-peers, translation-rules, etc.?

Because if you don't, the best is that you engage a reputable professiona or UC certified Cisco partner for the job.

George Moussa M... Thu, 03/29/2012 - 03:56
User Badges:

Yes, I know the dial-peer very well and I put the bellow configration of DID and didn't work

dial-peer voice 1 pots

corlist outgoing local-VM

description ** Inside Cairo **

destination-pattern 9[2-9].......

incoming called-number .


port 0/2/0:15

forward-digits 8

Even I put connection plar 100 on the voice-port 0/2/0:15 to send all the incoming calls to the secrtary office, when I remove this command any one calls the company a message tells him that this number is not correct and when I put it back it rings !!

also I tried these configrations and fail

voice translation-rule 1

  rule 1 /^226492/ /2/


voice translation-profile pstn-in

  translate called 1


voice-port 0/2/0:15

  translation-profile incoming pstn-in

ronpatel Thu, 03/29/2012 - 04:04
User Badges:
  • Blue, 1500 points or more


What is the DID number you are hacing and send us debug voip ccapi inout and ISDN q931 output.


Ronak patel


This Discussion