×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

auto qos not able to configure

Unanswered Question
Mar 29th, 2012
User Badges:

Hi,


I tried to configure auto qos in GNS3. When i tired to configure auto qos voip trust command, i encounter the following error.


Router(config-if)#auto qos voip trust

%Error: FastEthernet1/7 Service Policy Configuration Failed.Only IN Direction Supported

AutoQoS Error: the following command was not properly applied:

service-policy output AutoQoS-Policy-Trust

Router(config-if)#


Not sure what this error is. Can you tell me how to configure Qos for CCNP exam.


Also is there a way to simulate and test Voip configurations in GNS? I tried to find a lot of ways, but could not found. Can you also help me in that part.


Thanks

Chidambaram

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion

Related Content