×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Reorder Dial Peers?

Answered Question
Mar 30th, 2012
User Badges:
  • Blue, 1500 points or more

Hi,


I have configured a CME 8.6 router with 20+ dial peers. I would like these to appear in the config based upon the numeric value assigned to the dial peer.


It seems that they appear based upon the order of configuration.


Is there any way (short of manually editing the config file and then uploading it) to reorder them?


I do not think this is possible but would like confirmation of this.


Thanks

Correct Answer by ronpatel about 5 years 4 months ago

Hi


It will come in order of configuratoin only.....you can remove the config and put the edit one again.


Regards

Ronak patel


Please rate helpful posts.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
ronpatel Fri, 03/30/2012 - 04:31
User Badges:
  • Blue, 1500 points or more

Hi


It will come in order of configuratoin only.....you can remove the config and put the edit one again.


Regards

Ronak patel


Please rate helpful posts.

James Hawkins Fri, 03/30/2012 - 05:51
User Badges:
  • Blue, 1500 points or more

Thanks Ronak,


I did not think this was possible but it is good to have that confirmed.

Aaron Harrison Fri, 03/30/2012 - 06:21
User Badges:
  • Super Bronze, 10000 points or more
  • Community Spotlight Award,

    Member's Choice, May 2015

Hi James


I think a reboot re-orders them. Or at least it used to...


Aaron

James Hawkins Fri, 03/30/2012 - 06:39
User Badges:
  • Blue, 1500 points or more

Hi Aarron,


Thanks for the response.


I have just tried a reboot and the dial peers remain in the order entered


I am running IOS 15.2. I will try this on some older verions when I get a chance.

Actions

This Discussion

Related Content