×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

How to configure connection between UCS FI 6120 to C2960S using Twin Ax cable ?

Unanswered Question
Mar 30th, 2012
User Badges:

Hi expert,


Just wondering is it possible to connect UCS FI directly to C2960S using Twin Ax Cable (3M long) ?


Was given a task to test it out, hope you experts could lend a hand



Cheers

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
yllow Sat, 03/31/2012 - 23:50
User Badges:

Hi Reza,


Thank for the information Greatly appreciated it alot.


However, i been encountered the following error while i connect Cisco Twin Ax (Cisco Branded) cable from FI to 2960S.


*Mar  1 00:32:22.764: %GBIC_SECURITY_CRYPT-4-ID_MISMATCH: Identification check failed for GBIC in port Gi1/0/25

*Mar  1 00:32:22.764: %PHY-4-UNSUPPORTED_TRANSCEIVER: Unsupported transceiver found in Gi1/0/25


Tried using the following commands as well as upgrade to latest IOS (15):


service unsupported-transceiver

no errdisable detect cause gbic-invalid


Still recevied the same error as above.


Should i be configuring trunk port on interface1/0/25 or ? i am confuse somehow =(


Hope to hear from you soon


Cheers

Actions

This Discussion