cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
404
Views
0
Helpful
4
Replies

configure backkup PSTN for WAN link on CUCME

ievalleyccie
Level 1
Level 1

I have 2 CUCME in 2 different Sites and connected with IPSEC VPN Wan Coonection and PSTN (FXO)

The dial plan of the Site-1 is 100x and Site-2 is 200x .

The Site-1 FXO line is 22513612 and the The Site-2 FXO line is 24576022

They are working fine through the WAN Link (Voip) but i'd like to configure The PSTN to be backup for the wan link without changing the Dial Plan

I need help in  the Config

1 Accepted Solution

Accepted Solutions

With the proposition expressed by your nickname, you should have no problem in reading user documentations.

http://www.cisco.com/en/US/docs/ios-xml/ios/voice/dialpeer/configuration/15-0m/vd-dp-overview.html

View solution in original post

4 Replies 4

paolo bevilacqua
Hall of Fame
Hall of Fame

Just tse lower preference dial-peer(s) for the same patters.

Thanks for your reply

Could you pls give me an example ?

With the proposition expressed by your nickname, you should have no problem in reading user documentations.

http://www.cisco.com/en/US/docs/ios-xml/ios/voice/dialpeer/configuration/15-0m/vd-dp-overview.html

thank you very much for your valuable reply

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: