×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

2F BLSR cannot clear lockout

Unanswered Question

Greetings.


I have a 2F-BLSR and I upgraded from TCCs to TCC2s. All went well until I went to remove my locks from the spans, but it just locks up the whole network in that I have to reset (physically or manually) the TCC cards to get back to CTC!


I can clear one segment with no issues, but the second one hangs the system as above.


Fiber is running clean, zero errors.


Is there something I should look for or an order to bringing the ring back up to fully protected? It is running unprotected now.



????


Software is 09.208-101.H2606

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Tom Randstrom Mon, 04/09/2012 - 19:35
User Badges:
  • Gold, 750 points or more

Have you submitted this case to Cisco TAC? 


Which control cards were you starting from, TCC or TCC+?  I don't believe it would be possible to directly upgrade from a TCC to TCC2 without using a TCC+ card in-between (due to software compatibilites). The TCC is compatible up to 2.x, The TCC+ up to R4.1, the TCC2 starts at R4.0. 

Actions

This Discussion

Related Content