cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1868
Views
0
Helpful
1
Replies

NX-OS EEM command/pattern option

pfillips11
Level 1
Level 1

Hello,

In IOS under EEM action we have command and pattern options to provide an imput based on specific pattern. I can not find that option in NX-OS. Is there any other syntax in NX-OS for similar application? Basically on a specific track down event I need to telnet to other NX-OS sytems and am trying to get it done using EEM on NX-OS. Any suggestions are appreciated.

Thank you.

1 Accepted Solution

Accepted Solutions

Joe Clarke
Cisco Employee
Cisco Employee

Unfortunately, this is not possible on NX-OS.  EEM on NX-OS is EEM by name only.  The feature is very different than it is on IOS.  What you could do is use an IOS box as a proxy.  That is, send a trap using EEM from your NX-OS box, then have IOS do the telnet to the other NX-OS box to perform the necessary commands.

View solution in original post

1 Reply 1

Joe Clarke
Cisco Employee
Cisco Employee

Unfortunately, this is not possible on NX-OS.  EEM on NX-OS is EEM by name only.  The feature is very different than it is on IOS.  What you could do is use an IOS box as a proxy.  That is, send a trap using EEM from your NX-OS box, then have IOS do the telnet to the other NX-OS box to perform the necessary commands.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: