cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1239
Views
0
Helpful
7
Replies

Radios on 1242AG stay down with Injector and Cat6509

sbreuercc
Level 1
Level 1

Dear all,

i noticed that the 1242AG does not bring up the Radios, when there is a Power Injector connected.

I see in the Logs of the AP:

%CDP_PD-2-POWER_LOW: All radios disabled - NEGOTIATED WS-C6509 <Switchport MAC Add>


The Module in the 6500 is a   WS-X6348-RJ-45

The Option "Power Injector installed" on the WLC is also enabled, with the MAC Address from the Switchport, but no change.

WLC.JPG

When i disable CDP on the mentioned Switch Port and reload the AP, it comes up and runs fine.

Any ideas, what is causing this problem?

BR.

stefan

7 Replies 7

Scott Fella
Hall of Fame
Hall of Fame

Isn't there another option on the wlc in regards to the power. IIRC, there are two options, try checking the other option.

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***

the other option is "override" in the field "Power Injector State".

but this didn't change the problem.

What is the WLC firmware?

WLC Soft is  7.0.116.0

AP Soft is  12.4(23c)JA2    / Boot Version 12.3.7.1

Is this the only WAP that's having a problem or are there more.

If this is the only WAP then check your cables.

yep, this is the only one.

will check the cables.

problem fixed, with replacing the power supply and cables.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: