×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Config a Snombox PA1 on UC560

Unanswered Question
Apr 20th, 2012
User Badges:

Hi,


For a customer, I need to configure a Snombox PA1 on a UC560.

The PA1 is in fact a SIP-device which allows to speak on a PA-system through your phone (you just call the extension of the PA1)


Now, officially, 3rd party SIP-devices are not supported on a UC560.

With a little help on the web and this forum, I have been able to configure the UC560 via CLI and the PA1 has registered with the UC.So far, so good...

But: when I try to call the extension of the PA1, nothing happens. It seems like the UC doesn't recognize the extension 777 (as it does not appear in the CCA)


Config:


voice register global

mode cme

source-address 10.10.0.253 port 5060

max-dn 20

max-pool 10

authenticate register

date-format D/M/Y

file text

create profile sync 0615060624011404

!

voice register dn  1

number 777

allow watch

name PA

label 777

!

voice register pool  1

id mac 0004.1333.0595

number 1 dn 1

dtmf-relay sip-notify

username 777 password 12345

codec g711ulaw


I've even tried to create a dial-peer like below, but that doesn't help


dial-peer voice 5010 voip

description **** PA ****

destination-pattern 777

session protocol sipv2

session target ipv4:10.10.0.253

session transport tcp

dtmf-relay rtp-nte

codec g711ulaw

no vad



Anyone any insight?


Thanks!

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
paolo bevilacqua Fri, 04/20/2012 - 03:24
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Most likely, the device is not registering. There are various commands used to troubleshoot, if you search in "ip telephony", the matter is often discussed.

Actions

This Discussion

Related Content