cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
553
Views
0
Helpful
2
Replies

WLC 5508 question setup

Darren Spooner
Level 1
Level 1

i have 12 locations all connected to internet via T1 and connected to HQ via VPN all sites have asa 5505 and HQ has asa 5510

we are adding another building at a site and it will have an asa5510 with its own internet connection. VLAN 1 that is behind this new asa5510 will be connected to one of the site's VLAN1. the VLANs that will be behind this new asa5510 will all be guest (apparements 1 VLAN per appartemnt)

the internet connection will be a 100Mbps connection.

now i think that is all the basic info so here is my quetion i want to setup the 5508 at HQ so we can deploy wireless at all sites including the appartmens.

is this possable? i want to have all appartment traffic to go to their asa5510 internet not through HQ

thanks

Darren

1 Accepted Solution

Accepted Solutions

Scott Fella
Hall of Fame
Hall of Fame

You can setup the AP's at the remote site for H-REAP/FlecConnect.  This will allow you to say, ssid 1 (internal users) connect back to HQ, ssid 2 (guest) you get placed on the remote site vlan X.

http://www.cisco.com/en/US/docs/wireless/controller/7.2/configuration/guide/cg_flexconnect.pdf

-Scott
*** Please rate helpful posts ***

View solution in original post

2 Replies 2

Scott Fella
Hall of Fame
Hall of Fame

You can setup the AP's at the remote site for H-REAP/FlecConnect.  This will allow you to say, ssid 1 (internal users) connect back to HQ, ssid 2 (guest) you get placed on the remote site vlan X.

http://www.cisco.com/en/US/docs/wireless/controller/7.2/configuration/guide/cg_flexconnect.pdf

-Scott
*** Please rate helpful posts ***

thanks for you help :-)

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: