WLC 5508 question setup

Answered Question
Apr 26th, 2012

i have 12 locations all connected to internet via T1 and connected to HQ via VPN all sites have asa 5505 and HQ has asa 5510

we are adding another building at a site and it will have an asa5510 with its own internet connection. VLAN 1 that is behind this new asa5510 will be connected to one of the site's VLAN1. the VLANs that will be behind this new asa5510 will all be guest (apparements 1 VLAN per appartemnt)

the internet connection will be a 100Mbps connection.

now i think that is all the basic info so here is my quetion i want to setup the 5508 at HQ so we can deploy wireless at all sites including the appartmens.

is this possable? i want to have all appartment traffic to go to their asa5510 internet not through HQ

thanks

Darren

I have this problem too.
0 votes
Correct Answer by Scott Fella about 3 years 3 months ago

You can setup the AP's at the remote site for H-REAP/FlecConnect.  This will allow you to say, ssid 1 (internal users) connect back to HQ, ssid 2 (guest) you get placed on the remote site vlan X.

http://www.cisco.com/en/US/docs/wireless/controller/7.2/configuration/guide/cg_flexconnect.pdf

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)

Actions

This Discussion

 
 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode