×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

conference hardware on telephony-service can not complete conference

Unanswered Question
Apr 27th, 2012
User Badges:

Dear guys

Set the meet-me and ad-hoc conference function on our CME router , the i have created a meet-me conference and concall another phone by g.711 from admin phone ,the phone screen display "can not complete conference" what reason with this problem ? 

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
yun zhang Fri, 04/27/2012 - 20:43
User Badges:

Dear anchoudh

thanks  for your information, yes i have checked the all phones enabled dual-line , otherwise i have deleted the conference hardware under the telephony-service. it can conference call but restrict in three parties.

anchoudh Fri, 04/27/2012 - 20:55
User Badges:
  • Red, 2250 points or more

Hi Yun,



For Ad-Hoc conferencing, please make sure you have the phone configured  as Octo-Line and not Dual-Line, this way you can have up to 8 active  participants, otherwise if you want more then use Meet-Me.


So please change it according on these phones and try.


Thanks,

Anand


Please rate helpful posts by clicking on the stras below the right answers !!

yun zhang Sat, 04/28/2012 - 01:48
User Badges:

Dear

I have modified the phone-dn type from  Dual-Line to Octo-Line  , but still not complete conference when i created a meet-me conference . anyway for this ???

paolo bevilacqua Sat, 04/28/2012 - 03:59
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

You can have a mistake anywhere in config, review it again.

Actions

This Discussion

Related Content