Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
1441
Views
0
Helpful
2
Replies

operator number response delay with UC520-32U-8FXO-K9

net1998ashraf
Level 1
Level 1

‎04-29-2012 02:13 AM - edited ‎03-21-2019 05:43 AM

dear all

i have UC520-32U-8FXO-K9 currently installed in my office with 15 ip phones connected to it , i have operator IP phone model 521S , the operator number is 700 , i have 5 PSTN lines connected to this system , i faced probelm when the outside caller call our PSTN lines it take two rings until the operator phone ringing so the operator pick up the phone in the ring number 3 from the caller side could you please advise is that normal or not ?

best regards

Labels:
0 Helpful
2 Replies 2

nalbert
Level 4
Level 4

‎05-01-2012 09:40 AM

Hi Net1998ashraf,

It is going to very difficult to get an answer to your question since the SPA 521S is not officially supported with current version of the UC520. You are dealing with an unsupported config. The SPA phone likely waits for Caller ID before it starts ringing.

0 Helpful

net1998ashraf
Level 1
Level 1
In response to nalbert

‎05-05-2012 08:41 AM

dear Navin

could you please explain your answer becuase i could not understand it

best regards

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents