Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Cisco Antenna (AIR-AP1242AG) Question

Unanswered Question
Apr 29th, 2012
User Badges:

Is the below Cisco Sector Antenna AIR-AP1242AG rated for outdoor installation/mounting or is it indoor mountable only?

Also does anyone know if it comes with U-bolts/clamps for mounting to a mast/pole?

Dimensions and Mounting Specifications

Azimuth Plane Radiation Pattern

Elevation Plane Radiation Pattern

Frequency Range

2.4-2.5 GHz


1.5 or less


5.0 dBi


Linear vertical

Azimuth 3dB Beamwidth

135 degrees

Elevations 3dB Beamwidth

54 degrees

Antenna Connector


Cable Length

3 ft. (91 cm)


6 x 3 x 2 in (15.2 x 7.6 x 5 cm)


Wall Mount

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Rob Huffman Mon, 04/30/2012 - 06:01
User Badges:
  • Super Red, 40000 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 IP Telephony, Unified Communications

Hi there,

The Antenna you have referenced is an AIR-ANT2450S-R the specs are shown below

AIR-ANT2450S-R Sector, 1 port Wall mount indoor/outdoor antenna with RP-TNC connector for use with any

2.4 GHz radio. Capable of covering large areas. The plenum rated cable is 36” long.


It is listed as a "Wall Mount" so it doesn't come with any u-bolts.



"Everything is broken" - Bob Dylan


This Discussion

Related Content



Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode