SPA303 phone stuck- how to reset?

Unanswered Question
Apr 30th, 2012

I've got a Cisco SPA303 phone that is stuck at "Initializing Network".  How do I factory reset it?  I can't seem to get into any configuration menus or settings.  The manual says to press **** and choose 4 and hit # but nothing happens.  Is there some secret to getting it reset?

Thanks,

Chris

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Average Rating: 0 (0 ratings)
nseto Thu, 05/03/2012 - 10:26

The spa303 uses the phone UI (no IVR for **** on that model), press the button below the envelope button.  That would be the setup button, then go down to item 14 for factory reset, select it and ok it.

If the

"Initializing Network" is not allowing you to get to the phone UI, then disconnect the network cable and you should be able to get into the menu.

MVermeulen2006 Thu, 11/08/2012 - 22:19

Hi

I have an SPA303 that is stuck on initializing network. It stays in that mode no matter which buttors are pressed, with and without the lan cable plugged into the phone.

are there any other ways to perform the factory reset?

dan.berla Tue, 03/26/2013 - 01:23

Hi, when your cisco is "initializing network" u have to press the volume button on the right then when u're in the volume settings menu, press the setting button (under the messages button). Go to item 14 and reset the phone byz

Actions

Login or Register to take actions

This Discussion

Posted April 30, 2012 at 4:59 PM
Stats:
Replies:3 Avg. Rating:
Views:7984 Votes:0
Shares:0
Tags: reset, phone, spa303
+

Related Content

Discussions Leaderboard