05-02-2012 10:55 AM - edited 03-11-2019 04:00 PM
Is it possible to configure WOL through FWSM in routed mode?
We are running version 4.0.
Solved! Go to Solution.
05-02-2012 12:01 PM
Hi Dominic,
In the directly connected subnet, the FWSM would not be able to pass the broadcast traffic, but if its just a pass-thru then the directed broadcast is just like a unicast traffic and that can be allowed. You have two options:
Either use transparent firewall
or
Do not put the FWSM in the directly connected subnet as the users, you can put the users in a different subnet and keep the FWSM one L3 hop away.
Hoep that helps,
Thanks,
Varun
05-02-2012 11:11 AM
Hi Dominic,
is the FWSM just a pass-thru device or is it the edge device for the directed bbroadcast and supposed to perform the replication?
Thanks,
Varun
05-02-2012 11:38 AM
Hi Varun
It could be considered as both, pass-thru and edge device. The WOL server is on a VLAN directly connect to a FWSM interface. We have some targer machine on VLAN directly connect to a FWSM interface and other target are reachable througt a point to point to our distribution router.
Thanks for your help
Dominic
05-02-2012 12:01 PM
Hi Dominic,
In the directly connected subnet, the FWSM would not be able to pass the broadcast traffic, but if its just a pass-thru then the directed broadcast is just like a unicast traffic and that can be allowed. You have two options:
Either use transparent firewall
or
Do not put the FWSM in the directly connected subnet as the users, you can put the users in a different subnet and keep the FWSM one L3 hop away.
Hoep that helps,
Thanks,
Varun
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: