05-02-2012 06:21 PM - edited 03-07-2019 06:28 AM
Hi, there were three 3750s in a stackwise configuration but later it was decided to remove sw #1 from the stack and make it a standlone sw. I was trying to reconfigure the new combination and tried renumbering the switches and also changed the priority but the switch #1 in a stack if 2 now, shows three switches still!?
how can I make sure that new configuration is done clean and the master switche only shows two switches with switch number 1 being master i.e. with "*"?
Please advise,
Masood
05-02-2012 06:31 PM
conf t
no switch 2 provision
no switch 3 provision
end
wr
05-02-2012 06:55 PM
Thanks.
I did no switch 1 provision
then, I used the same command to add the second one.
is there a way to remove stackwise config altogther and just add what is needed?
Thx,
Masood
05-02-2012 07:04 PM
I did no switch 1 provisionwhen they had remove/recabled the first one so I had to configure the seocnd to be the first one
You want the second switch to be the first what? First switch or the master switch?
is there a way to remove stackwise config altogther and just add what is needed?
You want to remove the config of the existing switch stack or just the one you've pulled out? If it's the one you've pulled out, just ERASE the config and reboot.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide