Cisco Wireless Multicast Setup, One Subnet, To Enable Apple AirPlay

Unanswered Question
May 4th, 2012
User Badges:

Hi,

I’m having issues with enabling Apple’s AirPlay services on a relatively simple network consisting of a Cisco 881 (Advanced IP Services) and an autonomous Cisco 1142 AP. I’ve attached a diagram explaining the connectivity. I believe I have to enable IP Multicast at the router, but I’m not really sure the best/right way to do it. Also I’m not sure what/if any commands would be needed at the AP.


All of the wireless clients are confirmed to be in the same subnet, so no real routing is happening etc. Also regular Internet connectivity/routing from the wireless clients is fine.


Any help would be greatly appreciated. Thanks.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Scott Fella Fri, 05/04/2012 - 15:21
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 Wireless

There are other threads on this, but this one might help


https://supportforums.cisco.com/message/3520397#3520397


This will explain on the switch side:


https://supportforums.cisco.com/docs/DOC-24187

MrPrince1979 Fri, 05/04/2012 - 16:04
User Badges:

Thanks for the two URLs. The first might be promising, but the second involves a WLC which I don't have. This is where I'm essentially getting stuck R.E. configs for both my wired 881 and my autonomous 1142.

Scott Fella Fri, 05/04/2012 - 16:26
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 Wireless

The second link has a small section on the wired multicast side.


Thanks,


Scott Fella


Sent from my iPhone

MrPrince1979 Sun, 05/06/2012 - 17:29
User Badges:

I've tried the commnd [ no ip igmp snooping ] on the AP. Still nothing. I've also enables Multicast routing on the 881 using:


881(config)# ip multicast-routing

881(config-int vlan50)# ip pim dense-mode


Still nothing...

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode