ā05-06-2012 03:30 AM - edited ā03-01-2019 05:34 PM
Hello Cisco experts.
While working with Cisco router with IOS 12.4(25b) I noticed that
I can configure "ipv6 host" that can contain multiple ipv6 addresses,
I would like to use it in ipv6 acl but it seems that I can't.
Is there syntax or IOS version that allow me to use "ipv6 host" in ipv6 acl?
thank you
Solved! Go to Solution.
ā05-12-2012 03:25 AM
Yes you can. ;-)
In this link is the syntax described to use a host as source or destination in an acl:
http://www.cisco.com/en/US/docs/ios/ipv6/configuration/guide/ip6-sec_trfltr_fw.html#wp1072522
regards,
Leo
ā05-14-2012 05:36 AM
Hello Josef,
Here is another configuration example
IPv6 Traffic Filtering Access List Configuration Example
Regards,
Sunil.
ā05-12-2012 03:25 AM
Yes you can. ;-)
In this link is the syntax described to use a host as source or destination in an acl:
http://www.cisco.com/en/US/docs/ios/ipv6/configuration/guide/ip6-sec_trfltr_fw.html#wp1072522
regards,
Leo
ā05-14-2012 05:36 AM
Hello Josef,
Here is another configuration example
IPv6 Traffic Filtering Access List Configuration Example
Regards,
Sunil.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: