Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Missing vpn client configuration group command - old 2600 router - looking for IOS

Unanswered Question
May 10th, 2012
User Badges:


I need to create a Cisco VPN Client connection:

I am following the cisco vpn client link and I don't have the command

crypto isakmep client configuration group XXXXX


This is what I get:

crypto isakmp client configuration ?

  address-pool  Set network address for client

This is my show version, any ideas if there is an IOS that will work:

Cisco Internetwork Operating System Software

IOS (tm) C2600 Software (C2600-IK9S-M), Version 12.2(17a), RELEASE SOFTWARE (fc1)

Copyright (c) 1986-2003 by cisco Systems, Inc.

Compiled Thu 19-Jun-03 16:35 by pwade

Image text-base: 0x8000808C, data-base: 0x81280FF0

ROM: System Bootstrap, Version 12.2(7r) [cmong 7r], RELEASE SOFTWARE (fc1)

MYROUTER-- uptime is 23 hours, 5 minutes

System returned to ROM by power-on

System image file is "flash:c2600-ik9s-mz.122-17a.bin"

This product contains ...etc etc

cisco 2611XM (MPC860P) processor (revision 0x100) with 60416K/5120K bytes of memory.

Processor board ID JAE0716032R (3260324458)

M860 processor: part number 5, mask 2

Bridging software.

X.25 software, Version 3.0.0.

2 FastEthernet/IEEE 802.3 interface(s)

32K bytes of non-volatile configuration memory.

16384K bytes of processor board System flash (Read/Write)

Configuration register is 0x2102

Any ideas as to what IOS can do the trick for me???  Or is it even possible?


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)


This Discussion

Related Content