cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2200
Views
0
Helpful
5
Replies

Call disconnection problem over FXO ports in CME

owaisqadri
Level 1
Level 1

Dear all,

I have a setup of CME 8.5 in which i am using analog lines for incomming & outgoing calls which are connected to 4 FXO ports.issue calls are not disconnecting properly getting this issue peridocally, It seems calls are getting stucked on FXO ports due to this reason line are getting busy. than only solution is is to physically remove the analog line or shut or no shut fxo ports. below is the configuration for your reference.need your help to resolve this issue.

voice class custom-cptone SaudiTelecom

dualtone disconnect

  frequency 425

  cadence 250 250

voice-port 0/1/0

supervisory disconnect dualtone mid-call

voice class custom-cptone SaudiTelecom

battery-reversal

input gain 7

output attenuation -1

echo-cancel coverage 32

cptone BR

timeouts call-disconnect 3

timeouts ringing 5

timeouts wait-release 3

timing hookflash-out 500

timeouts wait-release 3

connection plar 111

impedance complex1

caller-id enable

caller-id alerting line-reversal

caller-id alerting dsp-pre-allocate

5 Replies 5

Hi,

Try to add:

voice class dualtone-detect-params 1

freq-max-deviation 50

voice-port 0/1/0

supervisory dualtone-detect-params 1

HTH,

Alex

*Please rate helpful posts

paolo bevilacqua
Hall of Fame
Hall of Fame

If disconnect doesn't work, then the configured tones are wrong.

Thanks all for your inputs.. i tested all the above inuts but still same issue.

after trouble shooting i noticed that when i am calling from mobile or L.L to compnay number which is hittting gateway & the call is routing to operator if operator is not picking up the phone & enduser is disconnecting the call but operator phone is still ringing no disconnection is happing.

Hi,

You should check the disconnect tones as Paolo suggested.

Best regards,

Alex

To alleviate this problem you should use connection plar opx.

you should also try cadence 500 500

Also note that most of the other commands you have configured, are useless.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: